Recent content by Tbutler

Looks awesome!

Awesome thanks!

Thank you, just wanted it safe, my grandson just turned 3........its a predator 212, i removed the governor, and built a straight pipe, re jetted and added an air filter.

Thank you...............you have more patience than i have looking for everything :-)..........I have a battery mounted behind the seat, the light bar is more for aesthetics than anything.

Thank you..............It is pretty loud :-) , will probably put a muffler on it, doesnt need more HP yet as he's only 3 :cool: , what muffler do you suggest?

Thank you!

Here is the finished product, the last picture is of the plans I purchased, a spidercart Arachnid.

I started on this project in March of 22' for my grandson(he just turned 3 a couple of weeks ago) the last picture is the plans that I purchased, a spider cart Arachnid, and the first few pictures are the finished product, I added a few in process pics along the way, it would have been way...

Mostly 1 1/4 square 14ga, not sure the brand of shocks, bought a parts kit from BMI karts

This was made from scratch?

no, it has been removed

i thought heat too but wasn't run for very long, have not changed the oil but pulled dip stick and looks brand new.

its a stock cap, shouldn't it be vented good enough? also i did install a torque converter, no shroud on it right now, would that matter?

I installed a new predator 212 basically stock except for a straight pipe, i can run it full throttle for a short bit and then it goes into like a limp mode where it will only run about 1/2 throttle, after it sits a bit it will run full throttle again, what can cause this? Thanks!

not sure color options with that?