Jacka$$withawrench's latest activity
-
Jacka$$withawrench reacted to BaconBitRacing's post in the thread Stuck Pillow Block Bearing with
Like.
Cut it off. That's what I had to do on my Streaker. If the angle grinder doesn't fit, use a Dremel with a cutting disk. -
Was fitting new Sprocket hub. Axle bearing is stuck on axle. Any tips for removal? I removed the set screws and tried torching, liberal...
-
By the way that’s not true for all of them, I got a girlfriend and I don’t even have a iPhone so…… and that power wheels helped me out...
-
It’s ok I already got a girlfriend I don’t need to impress anyone’s else
-
no, not where I go to school. maybe like 10-15 years ago. My mom won’t let me ride it (or get my license or let me drive until I’m 18...
-
You need a torque converter with a Genuine Comet Belt. And you need to mount a 60 tooth sprocket on the axle. After that you will be...
-
Probably cuz yer a bad parent. Smoking is stress induced. If your parenting skills were better, your influence would have kept it from...
-
Jacka$$withawrench reacted to Master Hack's post in the thread What is a good electric motor? with Like.
The red ones are even mo bedder!
-
Jacka$$withawrench replied to the thread What is a good electric motor?.If you don't have anything yet, you can buy old razor mx550 kids bikes of FB Marketplace and put them into small carts. That way you buy...
-
Jacka$$withawrench replied to the thread 110cc Single Tao Motor with 3 speed trans. What axle-sprocket tooth count should I run?.Thank you!
-
Jacka$$withawrench reacted to Whitetrashrocker's post in the thread 110cc Single Tao Motor with 3 speed trans. What axle-sprocket tooth count should I run? with Like.
The right turn fitting was what I had on hand. I get my bearings from carquest. Just looked up the size in the book.
-
Is it? Or does it just cause confusion?
-
Jacka$$withawrench replied to the thread 110cc Single Tao Motor with 3 speed trans. What axle-sprocket tooth count should I run?.I do. It's weird.
-
Jacka$$withawrench reacted to ezcome-ezgo's post in the thread 110cc Single Tao Motor with 3 speed trans. What axle-sprocket tooth count should I run? with Like.
It is if you have a 1-3/16" diameter axle.
-
Jacka$$withawrench replied to the thread 110cc Single Tao Motor with 3 speed trans. What axle-sprocket tooth count should I run?.I found this for $15, is it a good deal? Pillow Block Assembly | 3013-2806 | BMI Karts and Parts